i build my first 1070 ring yesturday
but it get a lot of trouble now
Temp: GPU0: 65C GPU1: 60C GPU2: 54C GPU3: 57C
GPU0: 391 Sol/s GPU1: 333 Sol/s GPU2: 336 Sol/s GPU3: 385 Sol/s
Total speed: 1445 Sol/s
......
but it get a lot of trouble now
Temp: GPU0: 65C GPU1: 60C GPU2: 54C GPU3: 57C
GPU0: 391 Sol/s GPU1: 333 Sol/s GPU2: 336 Sol/s GPU3: 385 Sol/s
Total speed: 1445 Sol/s
......
It's very low hashrate for GTX1070. What is your OC settings? Do you use 0.3.4b version of EWBF? It also could be because of Windows build version. I had similar problem with Win10 without Aniverssary update. After reinstalling to 1703build hashrate became normal (470Sol/s at 150W consumption)
It might also be worthwhile to check you CPU load. Your PSU is powerful enough?
Did you install afterburner and made any custom settings? It looks a little bit as if the cards don’t have enough power.
i switch the gpu's with an other computer
it was always crashing did not mater underclock overclcok stock or whatever
maybe old am2 motherboard are not compatible ?
switched with an am3+ with rx560 now both ring are running normal
getting 410 with little oc they doing 390 at stock i did not try high oc yet
but first i have to update windows again on that one it s running an older win10 (so cannot do eth)
gonna need to do a fresh install the ssd is to small for an upgrade
i tried to clone a bigger ssd to a smaller but it make trouble (even there is all the data in the begin of the disk) the reported ssd size is wrong even after scandisk)
and when you use it it make strange thinks, like i change computer ip but after reboot the old one is back just act like my profil is read only)
I had almost same problem. Recently, I switched to simpleminingOS and it is much much more stable now. It will worth for a shot!