flashed to bios f22, Disabled every chipset from the bios everything is working fine now good luck everybody

So yes add globalminer claymore to your local.config and run sudo update-miner claymore && sudo service ethos-miner-monitor restart


add dcoin -sc to you claymore.stub.conf

Everything is working good now , good luck to you all

change -dcoin sia to -dcoin sc , but still not working for me

What did you change exactly ?  my card start, lights on etc but they just are not recognized on ethos.

I checked everything coming from psu, interverted everything still the same result, cards on risers not detected. Starting to suspect my 6 risers. I use only one vga cable per card too is it the way to go ?

Also there is 4 switchs close to the pciE16 has it something to do with pci slots ?

This is a gigabyte mobo not msi, this is the f21 bios from january 2017


I can not find anything about pci inside, can i boot to uefi ? I m pretty lost, i can flash it to f22 but i m pretty sure it won t change anything

I don t know if it can help anybody to find a solution but here are the specs

1. 1 x PCI Express x16 slot, running at x16 (PCIEX16)
* For optimum performance, if only one PCI Express graphics card is to be installed, be sure to install it in the PCIEX16 slot.

2. 1 x PCI Express x16 slot, running at x8 (PCIEX8)
* The PCIEX8 slot shares bandwidth with the PCIEX16 slot. When the PCIEX8 slot is populated, the PCIEX16 slot will operate at up to x8 mode.

3. 1 x PCI Express x16 slot, running at x4 (PCIEX4)
* The PCIEX4 slot shares bandwidth with the M2H_32G connector. The PCIEX4 slot will become unavailable when an SSD is installed in the M2H_32G connector.

4. 4 x PCI Express x1 slots
(All of the PCI Express slots conform to PCI Express 3.0 standard.)

Hello

Im new here , and here is my problem :

I m slowly building a rig as a newbie, until today I had a gigabyte  z170x gaming 6 with 2 rx580 on the pci express slots running perfectly on ethos.
I decided to upgrade it with 3 rx 570 so i bought them and thoose risers ( http://www.lazada.co.th/2017-ver006c-1x-to-16x-pci-express-riser-card-pci-e-extender-60cmusb-30-cable-sata-to-6pin-ide-power-for-btc-miner-intl-20501882.html?ff=1 )

Now i can not get any card connected with the risers working, either i plug it on the pci express or the pci.

I can see 3 issues

1/ All 6 risers are broken, or I bought wrong risers, i don t know I never used one but odds are slim it s pretty easy.
2/ Maybe should I change something in the bios but i don t see anything about GPU despite it is almost the last bios, f21
3/ you tell me


Thank you !

Just used the exact same setup in my claymore.stub.conf and nothing shows up, I have no idea how to test it