I have try without and it stopped mining after few minutes, I just used a powered USB hub and everything is fine now,
(no additional parameters regarding the frequency), 10.5gH in average

Hi there

My miner does not start automatically when Minera starts, it appears off-line
I have to start ip manually

Any tricks to autostart ?

thx  to all of you
Cheers

Hi there,

Does some one knows how to set static IP address ?

Thanks to you folks !

Ok in the latest version, this field is still there, I ll try with with a FREQ of 150, then 100, then 50

I ll come back then to post results and feedback

Hi there, thanks fo the quick reply,

That's what I suspected
I see, I will invest then and come back to you
what about the freq you recommend ? -->>>  --gekko-2pac-freq 150
for sure I will add a fan too.

FYI I strictly followed the following tuto : https://speedwealthy.com/money/how-to-configure-minera-on-raspberry-pi-for-gekksoscience.compac-and-2pac/UQndxAfk-hM.html

Thanks to you !

Hi there,

same symptoms for me in Minera/Pi3/2Pac
I do not think something is missing.
after restarting the Pi3 I un/replugged the 2pac, activate the miner
it started to mine @3gh the the rate was falling until 0, in 3 minutes
it could be caused by the fact that my stick is plugged directly on my Pi3 and have no additional param to set-up the freq
(alos note that the light on the stick is green, always, do not know if it is normal)
thanks to all of you

Bye

Hi there,
for sure you can help, I have bee told !
Does some of you know if the version available here : http://ck.kolivas.org/apps/cgminer/ is compiled and ready to used under W10 ?
also, can you give an exemple of command line ?
Any recommendation to choose a pool ?

Sorry for being a newbie

have a nice day

Saab93