I am using Zotac AMP GTX1060 6GB (Micron too)
For me, the setting Core Clock +175, Memory Clock +650. The higher i set, my miner get error.
Power limit depend on what you want.
For me :
65% --> 295 Sols/s (+- 77watt, Eff 3.7Sols/watt)
75% --> 310 Sols/s (+- 90watt, Eff 3.5Sols/watt)
85% --> 325 Sols/s (+- 103watt, Eff 3.25Sols/watt)
I prefer 65% power limit, so my temp on 58-60 C.
I am using DSTM Miner on Win7..

Note : I notice something, i don't know if it's true or not.
Before, i am using Seasonic G650 for 4 GTX 1060 AMP and when i set core clock +175, my miner will get error about 12-18hours.
But, after i change my PSU to Corsair RM850X, my miner can stand about a week without get error.
I don't know if the psu could help you stabilize your miner..

That was the highest setting for hynix card for me.
When i try increased the clock, the miner not stable.
Atm, i decrease the power limit to 65% to all card (3 GTX1060 6GB and 1 GTX1060 3GB), the Sols/w on 6GB is 3.75 Sols/w, and 3GB on 3.55 Sols/w.
All of them on 75-78 watt average.
Note : The 3 GTX1060 6GB are Micron chip and GTX1060 3GB is Hynix.

Zotac GTX 1060 6GB AMP (Micron)
Hashrate : 323Sols/s
Miner : DSTM 0.5.3
Power Limit 85% (Average 90watt)
Temp Limit 75C (Average 65C)
Core Clock +175
Mem Clock +650

Zotac GTX 1060 3GB AMP (Hynix)
Hashrate : 298Sols/s
Miner : DSTM 0.5.3
Power Limit 80% (Average 85watt)
Temp Limit 75C (Average 65C)
Core Clock +144
Mem Clock +529

Both run in Win7 64bit..

Zotac GTX 1060 6GB AMP (Micron) 323Sols/s
using DSTM 0.5.3
Power Limit 85%
Temp Limit 75C (Average 65C on Open Air)
Core Clock +175
Mem Clock +650

Zotac GTX 1060 3GB AMP (Hynix) 298Sols/s
using DSTM 0.5.3
Power Limit 80%
Temp Limit 75C (Average 65C on Open Air)
Core Clock +144
Mem Clock +529