Explanation of the last few days from Neo.org/blog ...

https://neo.org/blog/details/3037

Hey Blissz, got a couple of questions/suggestions:

- Why did you slow the auto-speed fan so much ? Any reason ? Could you raised it again as it was after your first mod ? Or I won't be able to use auto-fan anymore !  My chip temps never got that high before your last mod.  Or maybe you can make some auto-speed fan profile like "silent" and "normal" ? Auto-speed was perfect because it allows the fan to run faster during daytime, and slower at night when the temp drops a little. But running too slow and it become useless, at least where I live with high temp daytime.

- Could you switch to your devfee pool at the end of the 2h period instead of before ? When we reboot to try different setting, you get much more than 1,5%. Not that I complain about your fee, but let's say you reboot 5 times an hour, you get like 7,5% instead of 1,5% for this hour. And I don't think anyone would bother rebooting every 1h55 to avoid it !

Thanks in advance.

First, back up your bitmain firmware: System / Upgrade / generate backup. That's the file you will use to roll back to your default firmware if needed.

Then set your frequency to 400, set your fan to 25%, and upload the new firmware. Just select the tar archive (can be downloaded on the first page of this thread), and upload. You do not need to extract anything.

I have to upgrade the firmware twice a day to keep up with all your release !!! 

I'm impressed. I no longer hear my D3, it doesn't get as hot, and it is much more efficient. I don't have a watt meter, but I get pretty stable result with:
- Lowest voltage
- 438 freq
- 15,7MH/s average
- auto fan speed 3,060 / 3,120
- Temp chip: 69 / 70 / 72

I guess it should draw about 763watt as lucasilverio stated a few post before (running at same frequency). Only a couple of HW. Have got the 01-15 nov batch (19,3GH/s).

Just one thing to add: THANKS A LOT blissz !!!

Ok, I got them back ! But it didn't worked using your contract adress: 0x8aA33A7899FCC8eA5fBe6A608A109c3893A1B8b2

Instead, I used the old? contract adress : 0x725803315519de78d232265a8f1040f054e70b98 / BETNEW / 18.
Now they appear again in the token list, but they shows 0$ value on etherscan... 

At least I can see them, and send them if needed !

Hope this help.

Same here. The tokens still show up in etherscan, but not on MEW.
Anyone figured it out ?

From their twitter account two days ago:


https://twitter.com/daocasino?lang=en