Hi blissz!

Auto reboot does not work

Hi Blissz, thanks for your work!
I use your firmware on 3 d3, it work more stable than on firmware from bitmain.

But I do not use the "auto-fan", because I'm afraid that long-term operation at high temperature can lead to a breakage of the boards.
Could you, please, take the target temperature into manual settings, so that everyone would decide what is more important for him, the silence or safety of the chips.
Thank you in advance!

The firmware worked without HW errors, but after 6 hours one blade fell into xxxx.
475 Mhz
16.5 GH/s
Voltage 16
Fan 50% ~4100prm