For those who could be interested, I finally succeed to run GTX1060 and RX580 together, via the config file Claymore.stub.conf:

-tt -70                                                                                                                                                                                       
-tt 30                                                                                                                                                                                       

Both parameters are usefull. It runs for more than 36 hours!

Happy new year ;-)!

Max

I have tried with only 1 GTX 1060 and 1 RX 580 in place of 2 RX 580 + 1 GTX 1050.

So, it seems the power supply has enough power to support at least 3 GPU ...

It mines correctly, until GPU temperature reach 61°C ... what is strange is that "-t 50" does not help in this configuration.
It works fine if GTX 1060 is alone ...

If someone understands this behavior ;-)

Regards,

Maxime

Thanks!

I already tried ... my conclusions are that RX580 + GTX1060 does not work ... it's fine with GTX1050, but not 1060.
I have configured a second miner so for NVIDIA ...

Maxime

Hi,

thanks for proposals.
I did used this config: https://www.zotac.com/us/product/graphics_card/zotac-geforce-gtx-1060-amp-edition#spec
I started with the smallest frequency without any success.

Unfortunately, there are not a lot of tools to check the GPU fan speed under ETHOS.

Does Claymore should be able to work with this config from a technical point of view?


Best regards,

Maxime

Hi,

I spent a long time to succeed mining with a mix of NVIDIA + AMD card (GTX 1060 + RX 580).

Everything goes fine until GTX 1060 reach 61°C ... then fan speed is about 11%, and after 1 or 2 minutes, GPU crash!
I get this error message: "nvml cannot get current temperature error 15".

Reboot, and back again to crash after a while.

I tried to adjust parameters in local.conf to reduce memClock or coreClock ... unsuccessfull.
I tried different solution in claymore.stub.conf ... same results.

Does someone did experiment same config, issue? (ethos, NVIDIA + AMD using Claymore).
Do I have to use another miner algo?

Many thanks!

Maxime