Show Posts
I registered just to post question, i am mining currently on nanopool, and i have 2 rigs mining ETN @ ~4250H/s each, so 8.5KH/s both, it never drops below it. For some reason current calculated hashrate is well below it at ~7140H/s and avg in last 6hours is ~7600H/s. This will be 20 hours since i started mining there and mined 294ETN which should give total for 24hours 350ETN.
At current difficulty as i am posting this (12512478072), i should be getting 420 (with 8.5KH/s) or am i not correct?
I previously mined ETH with nanopool and i didnt have those kind of problems, calculations always matched nanopool payout (1-2% up down). Am i doing something wrong or its just how it is?
My start_etn.bat file looks like this:
NsGpuCNMiner.exe -xpool stratum+ssl://etn-eu1.nanopool.org:13433 -xwal (walletAddress) -xpsw x -allpools 1
Also if someone could help me to identify my rigs (as different workers), do i just put DOT after wallet address or? Since at bottom page states 0 online, 0 offline and 0 total, i don't know if that can be an issue?
Thanks in advance
edit: I also forgot to add that rigs are working on lower temperatures than when they mine ETH (was 66-70), 57-64C, is that normal?
At current difficulty as i am posting this (12512478072), i should be getting 420 (with 8.5KH/s) or am i not correct?
I previously mined ETH with nanopool and i didnt have those kind of problems, calculations always matched nanopool payout (1-2% up down). Am i doing something wrong or its just how it is?
My start_etn.bat file looks like this:
NsGpuCNMiner.exe -xpool stratum+ssl://etn-eu1.nanopool.org:13433 -xwal (walletAddress) -xpsw x -allpools 1
Also if someone could help me to identify my rigs (as different workers), do i just put DOT after wallet address or? Since at bottom page states 0 online, 0 offline and 0 total, i don't know if that can be an issue?
Thanks in advance
edit: I also forgot to add that rigs are working on lower temperatures than when they mine ETH (was 66-70), 57-64C, is that normal?
Yout *.bat looks good. Look on Claymore's site, they have list of switches that you can use to identify GPUs. As far as H/s, this guys are getting swamped now (since NH hack) so there might be some glitches in calculation on their end. I am dealing with similar issue on another pool. I emailed them but still waiting to get the answer from their admin.
I hope its miscalculation i just want to know that i dont everything as it should be.
I am sorry, i didn't say it correctly. I want to identify my rigs as 2 seperate workers, so i can have more clear preview of results @nanopool.
I also sent email, yesterday, still waiting for response.
