So with my current setup I have a 20Mhz Crystal installed and using a trim pot I can get it to run but I cant get it to go ant faster the the 330ish that it runs at normally with the original crystal . I spliced in 5v directly from PC power supply and I am going in through the USB cable with the power.  at the moment all I can say is its running cool attached to an old CPU heat sink so no heat issues yet. i think I need more power but if I turn the trim pot down it errors out and stops responding.

resistor R1 is the one you want to change but you have to change it with a resistor that has a value that will match with the crystal you are using to run the asic chip at the desired speed. Bluestreak66 is the one who knows some of these working combos so far.

I will be reciving some stuff to test with today and will post my results. Even if I push it to hard and blow up my BE.

12sGmSYdRVtrU6JvehY56GeKdueLF7YCjY

12sGmSYdRVtrU6JvehY56GeKdueLF7YCjY

User name: ace

12sGmSYdRVtrU6JvehY56GeKdueLF7YCjY

Thank You 

I dont see it as the alt-coins being the problem. I think some will make as well