OK I FIGURED IT OUT

I had my Miner name in Caps, once I corrected that, I'm up.... and I see online stats...

I found I had to leave the other servers (Antminer) or it would just keep rebooting... are there different ports I can put in the other two slots on L3 Server settings, or just leave the antminer servers with no worker names like I have it now.... (I disable them when the pop up after reboots).






I've tried using the Antminer L3 on the factory settings which default to Antpool.    I followed all their instructions exactly, and I see lots of accepted tokens, but nothing on the antpool stats... nor on my monitor.  

So now I found Litecoinpool, I thought awesome, lets try them.

I setup the L3 by going into the Antminer L3 directly via its (DHCP) IP which I know, I've registered workers on litecoinpool.    I tell L3 "Save and Apply" and the antminer reboots continuously..  I factory reset, try again, same thing....  the only settings that appear to work are the Antpool servers....   And since I dont see any returns there, I've pretty much given up on that....

When I look at "Awesome Miner" dashboard... I see the litecoinpool but status is "DEAD" and unable to activate.... the antpool servers show too, but I deactivated them.... if I activate them, they turn green and work, but litecoinpool still shows "Dead"


Obviously I'm doing something wrong... any ideas?

All the best,

Joe