Show Posts
I'm using flypool and DSTM.
Your --user should just be your wallet adress, nothing else.
This is my line:
zm --server eu1-zcash.flypool.org --port 3333 --user t1XtiGPVNy8nz9BgxHVj9v2nCoaHe7sqq8U
Your --user should just be your wallet adress, nothing else.
This is my line:
zm --server eu1-zcash.flypool.org --port 3333 --user t1XtiGPVNy8nz9BgxHVj9v2nCoaHe7sqq8U
Then how do i determine the worker name? say i have two rigs: worker1 and worker2
Thanks
Check outgoing and incoming traffic through your router. Im using EU Flypool with no problems at all. There are more users here that uses Flypool.
Thanks..but i have no problem with EWBF, internet is very stable 24/7..either it is EU or Asia Flypool, port 3333 or 13333, EWBF runs smoothly..
DSTM is the problem here..
When I did my dstm testing, I was using flypool - WITH a worker address.
Your problem is NO PASSWORD.
Try adding "--p x" to the end of your command line in the bat file.
Your problem is NO PASSWORD.
Try adding "--p x" to the end of your command line in the bat file.
The README says:
--user Username / Workername
Does it mean Wallet / Worker? not Wallet.Worker (using "slash" instead of "dot") ??
The problem is not "not having a password"
I run fly-pool with no password. no problem. I have the same settings as tropulus (aswell as 3 workers).
I run fly-pool with no password. no problem. I have the same settings as tropulus (aswell as 3 workers).
But how did you determine the Worker name?
Tropulus did without WorkerName..say i have two rigs with same specs, i won't be able to know which one is active or down..
Thanks btw..
