My wallet just finished syncing and I have a zero balance. I'm currently mining at ZEROPOOL.CLOUD. I don't see an option to check my mining stats on the site. Can someone please tell me how to check stats. Thank you. I just want to make sure I setup everything correctly.

It worked! Thank you very much.

I'm using these two nodes:

zeropool.cloud
139.162.188.122

I had to change the port to 23800

Time to see if I got some coins.

In my zero.conf file I have the following two nodes listed:

addnode=35.164.216.74
addnode=94.176.235.178
rpcport=23800

Are the nodes still valid?

When I run ./zcashd

I get the following message:

Thank you for running a ZERO node!
You're helping to strengthen the network and contributing to a social good

Block height | 0
Connections | 0
Network solution rate | 0 Sol/s

You are currently not mining.
To enable mining, add 'gen=1' to your zero.conf and restart.

Since starting this node 5 minutes, 46 seconds ago:
- You have validated no transactions.

I have no idea why I'm not connecting to the nodes. I'm almost certain I setup everything correctly.

Can someone please let me know if the node addresses are still valid.

Thank you

Thanks for the reply. I do believe its the swing wallet. I followed this guide to set it up: https://github.com/vaklinov/zero-swing-wallet-ui

During setup I didn't recall seeing any error messages.

update:

I ran the following command: ./src/zcashd --daemon

And confirmed that it is running.

When I run ./src/zcash-cli getinfo

I get this:  "errors": "" Does this mean its working correctly?

./src/zcash-cli getpeerinfo gives me the following:
[
]

Is it ok to continue to mine? Or should I stop until the wallet issue is resolved?

I managed to get the OptiminerZero miner working correctly, Unfortunately I wasn't so lucky with the Linux wallet. The wallet is currently saying the following:

Blockchain synchronized: 0%
Up to 19-Feb-2017 7:00:00 PM

Network: 0 connections

I'm also getting these repeating messages:

Gathering of dashboard daemon status data done in 12ms.
Gathering of dashboard daemon status data done in 14ms.
Gathering of dashboard wallet balance data done in 7ms.
Gathering of dashboard daemon status data done in 12ms.
Gathering of dashboard daemon status data done in 24ms.
Gathering of dashboard daemon status data done in 16ms.
Gathering of network and blockchain info data done in 16ms.
Gathering of address/balance table data done in 15ms.

It would be greatly appreciated if someone helped me figure this out.

Thank you