Steps I took to get this working.
Open your command line and cd to the directory.
Run the following commands.
1. ipfs init
2. ipfs daemon --enable-pubsub-experiment
---Wait until you see Daemon is ready ---
Open another command/terminal
3. rcoind
4. open tkwallet
Once I did it in that sequence it seems to run. After doing these initial steps if you need to close it start at step 2.
rcoind -cli create (Creates a new address)
rcoind -cli "Wallet Name" (Loads cli interface)
If anyone wants to test my address is vms6isqmrrsihuxme67c46ijcojtmr2nmmtuoa3mj2p5hgwrvnbq
Open your command line and cd to the directory.
Run the following commands.
1. ipfs init
2. ipfs daemon --enable-pubsub-experiment
---Wait until you see Daemon is ready ---
Open another command/terminal
3. rcoind
4. open tkwallet
Once I did it in that sequence it seems to run. After doing these initial steps if you need to close it start at step 2.
rcoind -cli create (Creates a new address)
rcoind -cli "Wallet Name" (Loads cli interface)
If anyone wants to test my address is vms6isqmrrsihuxme67c46ijcojtmr2nmmtuoa3mj2p5hgwrvnbq
I was following the same thing.