Hi again. I swapped the crystal to 14.75MHz and added --icarus-timing short to the command but the BE still mines at an average of 365MH/s It is supposed to reach about 410MH/s.
This is my command in Linux
screen sudo ./cgminer-3.4.2/cgminer --icarus-timing short --config /home/luke/cgminer.conf
Is it OK or should I right it after the config?

Can any one help me please?

Left you a Positive trust rating 
Thanks again!

Thanks. Forgot that!! 

Me too. They all produce about 1% HW errors. And if you overclock them there is a chance that more errors may occur.

Hi. I have changed the crystal to 14.75MHz and R1 to 1.2Kohm. According to the table it should run at 412MH/s but it is averaging only 360Mh/s. What can be the cause. It is working fine but the hash rate did not increase as I thought.

Thanks elasticband. I got the Block Erupters today! Very satisfied.

I hope I'll receive mine tomorrow!!

1Cy9fwbtcN42jo26GuWkM8kzwZ5CLARGfR

I have rolled ten times.

Thanks!! 

Hi. I am interested in this. So if I understood correctly I just have to put those two banners in my signature and have to post a minimum of 50 posts per month. Did I got that right?

Here is my address 1Cy9fwbtcN42jo26GuWkM8kzwZ5CLARGfR
I just signed up at you site and rolled once.

Thanks. Great info!!

Hi. I just sent the payment to you elasticband. 

Can I order 4 USB BE please?

I am interested in buyind a blade. Is it worth it or not?

Me too. I am still a noob in this forum. I know this is for anti spam but it is very irritating!! Have to wait here for the time to pass.

Hello!! I am new too to this forum!!

I think it will get more and more expensive to buy BTC. The less there are the more expensive. That's my opinion.

I'm 20 years old and found out about bitcoin on a youtube advert and it got me!!