Replying to note that I have tried the Blade with two different PSUs and have realized that they are not the issue.

Giving .04 BTC to anyone who helps me find the solution.

First off, thanks for the reply! After reading your post I made sure cooling wasn't the issue by putting multiple fans both on the chip and heatsink. I have also completely rewired the blade using the molex splitter hack, and I am still running into the same issue. I'm almost certain that the PSU is not the issue - http://www.newegg.com/Product/Product.aspx?Item=N82E16817139051 - and I don't have the ability to try it with any other PSU right now. I'm just really eager to get this fixed. Thanks for the suggestions!

After finally getting my Block Erupter Blade up and running, it has started to restart at almost exactly 10 minutes, every 10 minutes. Additionally, there are 3 x's present in the "Chip" line on the configuration page.

These are shown in the screenshot below




I have been told that this means there is an issue in one of the power lanes, but that I cannot manually fix this issue due to the absence of power modifiers for each individual lane. I am hoping someone with more knowledge of the Blade can possibly help me out in finding a solution to this issue.

I thank anyone in advance who can possibly help me out, and I will provide any additional information if needed. I am willing to give someone a fair amount of bitcoins or compensation if they assist me in finding a solution to the issue.

After finally getting my Block Erupter Blade up and running, it has started to restart at almost exactly 10 minutes, every 10 minutes. Additionally, there are 3 x's present in the "Chip" line on the configuration page. These are shown in the screenshot below

http://gyazo.com/7ecff364517773124131ed711ec165aa

I have been told that this means there is an issue in one of the power lanes, but that I cannot manually fix this issue due to the absence of power modifiers for each individual lane. I am hoping someone with more knowledge of the Blade can possibly help me out in finding a solution to this issue.

I thank anyone in advance who can possibly help me out, and I will provide any additional information if needed.