I finally got minera up and running after days of trying (the SD card i was using was corrupted). WISH I HAD DONE THIS EARLIER!
Now I am running into a problem which I don't know is actually a problem or me just being a n00b pl3b, but as the subject line reads, my gekko's are not being recognized by minera.
My current set-up is Raspberry Pi 3 (B), 12-port usb hub, 3 Antminer U2's (all running as expected) and 2 Gekkoscience rev2.
I'm currently using cgminer with options "--anu-freq 250 --compaq-freq 150 --retries=1"
The 2 Gekko's don't even show under the devices. There was 1 instance where ONE of the Gekko's showed up (I'm assuming it was the Gekko with device # AMU0 (as opposed to Antminer ANU#)) but it was running at around ~220 MH/s...
I unplugged and plugged back in the both of them, and then it was back to square one with none of them showing up. I've tried using every possible usb slot I have as well. Both devices light up green when plugged in but that's it. Any suggestions??
I wanted to install cgminer-gekko but I'm not too comfortable with the custom stuff yet.
Any help would be greatly appreciated. In the meantime I luckily bought an extra RPi for sand box testing so I'll just install Raspbian on that for now for my Gekko's.
First of all gekko must be on USB 2.0 if connect to 3.0 it doens't work.
Then someone needs to add this:
dwc_otg.speed=1 to the file
/boot/cmdline.txtAdd it at start of line followed by space, then reboot and try again.
I’m having a similar issue. When I plug my U3 into a usb3.0 powered hub it is not recognized. Can i use the dwc_otg.speed=1 and where do I find the cmdline.txt file in the minera web ui?