Thank you for the response.

I will take the necessary precautions and try this out. Thanks for educating me. 

Normally, I use a legacy address for multisig. I would enter the legacy address public key and it would spit back the same receive address. The platform would then create a transaction with that info.


This time I used a segwit address from my trezor for the multisig. This time it came back as a legacy address. A legacy address derived from a segwit public key.

 I wanted to test and see if I sent funds to the legacy address that was derived from the segwit public key, would it be connected. The answer was no, lol.

Where I went wrong was using a segwit address instead of legacy address originally. Then I sent funds to test if the legacy address is tied to the original segwit address.

Any way I can access these funds in the address? I tried creating a legacy wallet with my trezor seed, but no transactions appeared. Is there a way to manually enter? Or am I completely off in my thinking. Does any of this make sense? It's late/early.

Thanks for reading

Hello, thanks for responding.

I took a public key from an address from my trezor (on electrum, right click address> details.)

The site I vend on asked for a public key of an address for multisig. I enter the public key and it generated that address. I then sent funds to that address. I believe the funds are on the trezor as well, It is just not showing in my electrum. How do I access/show funds on trezor/electrum from that address?

Hello,
Hoping you guys could help me figure what I did. New to bitcoin and still learning.

I sent funds from a electrum 2fa wallet to a multisig address I generated from a public key of my trezor wallet. How do I release funds?

This is the transaction:
54e6e32039c81424f14a2b24a11c7de8ae996ff9eaa1d3f3fa621acc8da72b55

A step by step guide would be great. Thank you in advance.