I completed the token swap, and for the most part the instructions are correct with one or two fuzzy areas. So I'll list my steps here.
1> I was on V0.04 wallet so I downloaded the V0.05 wallet, the purpose of this wallet just adds the swap token feature. You'll see all your current REBL and ETH in your V.05 without doing anything else differently. As soon as you install V.05 it replaces the V.04 program.
2>Fill in your personal Hash if you are required to fill the KYC form, otherwise use the hash in the wallet instructions.
So I didn't have over value $2500 in REBL so I didn't need the KYC form. I used the generic hash listed there when you do the "token swap" tab on V0.05
Fuzzy Note: The new V1.0 wallet generated a new R hash address for me
3>Verify your REBL ERC20 address. (this is your original receive token hash address) in your REBL wallet. Then proceed, (next tab) allows you to put in email address. This is very important, that you'll need access to this email address.
Fuzzy Note: I didn't create a new MEW wallet or anything like the screen prompted you to MEW. Some people are getting hung up on this step, not sure why the instruction sends you to MEW?
4> Copy your newly generated blockchain R address into the REBL ERC20 V0.5 wallet swap steps.
Sending your tokens to this address will activate our smart contract, and granting you your REBL coins on our new blockchain network.
Fuzzy Note, You need ETH in your V.05 wallet to pay for gas at (current normal rate) 4GWEI in there. I needed $0.000648 ETH there. Transactions won't process if you don't have enough there to pay for the gas!
Enter in you REBL total to swap, I actually was able to 3 decimal places, but they recommend only whole numbers.
Example: 10,231.098837 will delay or fail, use whole number such as 10231 but in my case I did 10231.58 and it took it. Completed
Fuzzy Note: The new wallet that the steps instructs you to download, the Rebellious-qt-_Mainnet.exe is V1.0 will run on you PC and will update the blockchain to current point in time, the first time it opened, it said something like six days behind, then in about an hour it was up to date. The following day, it said it was 19 hours behind (since I closed my PC down) after it updated the blockchain, my 10,23.58 token showed up in V1.0 wallet.
The V1.0 doesn't install a shortcut or program like the previous versions. You need to go to your download location to run the gui interface to bring it up again.
NOTE! When the V1.0 first installs, it shows your default location \\windows\users\appdata\... typically this is a hidden location in Windows and you could easily forget you have your token keys sitting there.
I changed this in that setup to to make mine C:\RebelTokens so I would easily remember not to delete the .dat file or location should I re-image my PC.
There note on this states:
*Don’t delete your wallet.dat file from the new REBL blockchain, this may lead to permanently losing your coins. We recommend to back it up and store it in a safe place.
Ok, I hope this helps you get over some of those stumbling points, you this just as a reference and NOT as a step by step.
Follow the instruction REBL laid out for the process, but some of those fuzzy areas this may help you through it.
I created these note the day after I actually did the swap, I can't guarantee accuracy but this is to the best of my recollection the day after and walking through the sequences again from REBL steps outlined.
Good Luck, please clarify if I made any mistakes or these instruction needs some editing, or toss my a bone if it helped you out.
Donate to:
RDR4xHnrDyoRsJwKAEQuY3usmVyDFBZooQ