Yes i reported....its kidding sh#t..only trolling....

Hope we can Talk now about interesting things...

ahh ok. I understand now, so i have to use the new SD file for using your FW2.x.
I will try your V2.3 when you release. I hope the best...

Hi can you explain what you update in the SD Card recovery V2.2.
Have i use this file again after i used your "old" SD card file? i have signature disabled and SSH access. Or is this new file neccessary for the new FW2.x ?

Have you fixed the fanspeed issue in your new FW? I will adjust my fanspeed manually and not by software.
I will try your new FW maybe tomorrow.

I used your FW 1.9 and 2.0 but i never could set higher frequency because of autotune. I hope you have fixed this now in your new FW.
I use your FW 2.0 now because i can use sometimes nicehash, but overclocking like you have discribed, would be nice.

i sent PM with Kernel details...hopefully

thanks
i will try this as soon as possible. Now my rig is rented so i don't want do changes...

just for my understanding(english is not my nativ language)
i choose the second freq in the row and after reboot i choose this freq again and apply and reboot again?

the following was hapend also while i tried ...the fan speed was fixed on 70% from me but they run only around 3450rpm 70% is normaly 1000rpm more....
the miner status page didn't showed me the setted freq...it shows me the standard autotune freq....is it possible your fw was not loaded complete? is this generally possible?
i will sent then kernel log.
i used stock freq. 718, and two other freq ( can't remember 725 and 731 ? low V and high V) but i never apply this two times.
my two psu are 220V (1Psu one board and mainboard, second psu the two other boards).
after renting is done i will test...

hm i can't belive this because i use 2 PSU with more than enough power.

freq and volt- settings not changed first

but thanks for answer

hi,

i tried your new version for z11(Antminer-Z11-Chipless-Nitro-v2.0-Public.tar.gz).
I removed SSH lock so far so good.
But after installing your firmware my miner boots up and after 1-2minutes he reboots ... and this again and again ... do you have an answer why?
Temp was not going over 80°C. First i didn't change frequency same problem.
i removed for now the firmware and with stock FW it works...
need some help please

Lars

aha...nice..

maybe anybody some more information for me 

Hi,

i tried mining DeM solo on prohashing. But every block i found was lost?!
I asked for the reason in forum by prohashing and i only get the the following answer:


Can anybody help ? Or is there an place were i can mine solo (DeM)?

I found securepayment, but this looks not realy secure;)

thanks for help

creadersback