Show Posts
When setting up the GA-H110 Installed the CPU and fan, plugged the GPU into the board for a startoff, got into bios fine and set the Gpu to pcie slot 1, turned on mining mode rebooted and it went into windows fine. I thought everything is ok..
Then turned off and put the gigabyte 1060 Gpu that was in the board onto a VER 009S powered riser.
Everything is on a single EVGA 1000 psu.
Rebooted and the CPU fan spun once then stopped and no post or boot.
Took the GPU out of the riser and plugged it directly into the M/b again.
Tried to boot again but its dead, no CPU fan starting, nothing - dead..
Any ideas on if I can reset the m/b, Have taken the battery out and shorted the cmos pins but still nothing.
The only thing that was different was it went onto a riser then M/B dead after that.
Then turned off and put the gigabyte 1060 Gpu that was in the board onto a VER 009S powered riser.
Everything is on a single EVGA 1000 psu.
Rebooted and the CPU fan spun once then stopped and no post or boot.
Took the GPU out of the riser and plugged it directly into the M/b again.
Tried to boot again but its dead, no CPU fan starting, nothing - dead..
Any ideas on if I can reset the m/b, Have taken the battery out and shorted the cmos pins but still nothing.
The only thing that was different was it went onto a riser then M/B dead after that.
You fried the mobo and cpu by connecting the riser, either that or its the powersupply
