@Sm3cK - Now that's cool! Maybe just one for the CAT?

I joined ypool recently and can't tell if there is a problem or not:

1) Whenever I go on ypool it shows that my worked isn't active. On jhprimeminer it looks fine and is finding shares.
2) ypool shows now XPM, but I'm sure I have a small amount by now.

Info:

• I have been mining for about 5+ hours.
• I am not using AVX because I am running a Phenom II x6 1100T.
• My miner.bat file looks similar to this:

(The username, worker, and password are all fake.)

Am I only supposed to have up to m4? I added m5 about 3-4 hours (while mining), so I don't think this should have an affect... Thanks for the help!

C'mon random number generator! Pick me!

KTG87pBBZqViyLuqTXgDxDQD93XsEUUXpr

Here's one w/ and w/o a ring:



Personally I like it w/o...

This is rather basic but the C is the face, the A is the ear, and the T is the eye...



You could always change the font and character size for different feels. For example, the C might even do better a bit wider.

1. In my room with a sleeping wife!
2. Had to cheat this a bit as I don't have 10 posts yet
3. Done.
3. LGSGhnPn5XRXGwueRxM3GvhNgQMLAmrrRW
4. Done?
5. Done.

I'm proud of you Klondike Coin!

Thank for the reply, I was afraid that this was a giveaway only forum!


I am in Asia, and I use my actual Primecoin address without the arrows (just too lazy to open it up right now).

Thanks again.

Free FRQ, yeah!

qdAPjBsRJH26anMGGqKmfpkoAMm6ozZwtL

https://twitter.com/LucidPhusion/status/425326344818286592

2QDXp7rer4hv8NAkyWRo4WzazPKxoe7nFq

Woohoo! Mooncoin!

The name always stuck in my head, so I gravitated towards it. When I finally saw the shibe on the yellow coin, I was hooked!

DHfCtwjm6fJFzqut3iPgHFJnm9iv8Dnsvz

Thank you!

Hi all! I'm new to the forum, but I've been lurking for quite sometime.

Anyways, I wanted to test out the waters of some alt coins. I have been doing a bit of Philosopherstone and Dogecoin recently. I decided to try out Primecoin on DigitalOcean. I followed this guide:

http://www.cryptocoinsnews.com/2013/12/04/primecoin-cloud-mining-using-digital-ocean-complete-guide/

Seemed simple enough, and I had the dependencies thanks to Dogecoin mining on DigitalOcean. However, when I get to the last command (to start mining), nothing happens... The console just accepts the command and waits for another??? I retried it several times, changing the order of the primeminer commands, the port, the IP address, the password, and still it does nothing.

I also tried this guide for good measure:

http://techupdates.com/go/643377#

It seems pretty good since it will auto restart after any crash, however, I just get a ENOEXEC error when I type in the "tail" command, and then the console gets stuck!

If anyone could give me any suggestions or advice it would be much appreciated. If it helps, I am using Debian 7 x64 with the cheaper of the 2-core options. Thanks!