Show Posts
|
Pages: [1]
|
Hello,
Been mining ETH on CudoMiner. Decided to run Phoenix as stand alone today. Immediately noticed I lost control of fan speeds with MSI Afterburner. Didn't really get it back properly after I switched back to CudoMiner either, until I figure out the problem. Can anyone point me in the right direction here?
Thanks!
|
|
|
Hey guys, trying to get 6 Vega64s to run stable. At this point after 10 minutes one or two gpu's dies, and the rig freezes. Looking for a stable bat file for startup. Speed isn't an issue at the moment, just want to keep it running. Any help appreciated! Thanks!
|
|
|
Anyone have an optimized .bat file for Vega64? I'm trying to run the x16 algo. Thanks!
|
|
|
Hey Guys!
Good looking project.
I'm wondering if you have plans to implement Bulletproofs into this coin?
I'm thinking that is almost a requirement going forward,and would help to differentiate this coin.
|
|
|
I too have seen the CN Heavy errors. I put in an issue request on Github, and emailed Cryptodredge per their website. Hopefully, they get a look at this soon!
|
|
|
How about some help with the transfer of old coins. All i get is the following error from the cli wallet:
"Error: failed to find a suitable way to split transactions"
Doesn't matter if I put in 5, 50, 500, or 5000, I get the same error
You have to split transactions. Check 'help' in cli wallet. I don't see nay help topics relating to splitting transactions. Can you be more specific.
|
|
|
How about some help with the transfer of old coins. All i get is the following error from the cli wallet:
"Error: failed to find a suitable way to split transactions"
Doesn't matter if I put in 5, 50, 500, or 5000, I get the same error
|
|
|
Thanks guys!
Followed all your advice, and I now have all 6 Vega 64's running! Now on to the next problem. Fans! All the fans want to run for a while, then stop momentarily before resuming, all at random moments (not all fans stop/start in unison, but they all do it). I can't seem to just get them to run continuously like my Nvidia's. I'm guessing it is some software issue.
Also, I now want to work on some power reduction as it's running full bore at 250W per card. Is this what the soft power tables address?
I'm reading and searching like crazy, and there is allot of advice out there.
Thanks again!
|
|
|
Thanks!
I found my answer at Vega.miningguides.com last night. Seems these drivers need to be reset every time you boot-up by disabling, and then enabling each card in Device Manager. Seems they have script to automate that. It did fix it and I was back to 1800h.
Now, I need to find out why when I installed the second card, the computer wouldn't see it!
|
|
|
Hello Everyone,
Setting up my second rig, this time with AMD Vega 64's. Last night, I installed my first card, started up MSI afterburner, and then started test mining XMR with the .bat file included with Cast XMR. 1780-1800 h right out of the box with no parameters set, other than fan curve in MSI.
Then I set it to mine some Graft Coin, (same V7 as XMR) with the same 1780-1800 result.
Tonight I come back to add second card, start it up and run it just for the hell of it (before adding the 2nd card). and all I'm getting is 1250 h!
Any ideas? I changed nothing in the bios or Cast XMR. I wanted to run this by someone before continuing. By the way, I'm using the Blockchain Drivers.
Thanks for any help you can give!
Mark
|
|
|
|