i keep getting failures on the hex 16A2
the failure keeps happening periodically and hexboard disables and then starts a new one -> might be over 30-50per day.
most of the time its ZOMBIE
or from faulty to DEAD.
re-starting everything sometimes help, but now i'm starting to get the following
(tried 3.xx and 4.0.0 and 4.2.2 versions)
HEXC failure -> disabling **** glibc detected - cgminer malloc(): memory corruption : 0x012dd718
what wrong?
the failure keeps happening periodically and hexboard disables and then starts a new one -> might be over 30-50per day.
most of the time its ZOMBIE
or from faulty to DEAD.
re-starting everything sometimes help, but now i'm starting to get the following
(tried 3.xx and 4.0.0 and 4.2.2 versions)
HEXC failure -> disabling **** glibc detected - cgminer malloc(): memory corruption : 0x012dd718
what wrong?
Visual check your HEX16C, see if there is any burn component.
You can get random restarts from using USB1 (too slow) or multiple power supplies on a shared USB hub (try a power protected hub or seperate everything) or one of the boards is leaking power on the USB (try taping out the gnd/+5V in the USB cable).
about burned component : No Visual problem seen, also works sometimes a while -> so mayby components ok!
about the USB -> i have USB2 cables but the board leaking might be the issue -> when pluggin in USB the fan spins, so mayby there is leakake eather way.
i will try to tape out +5V and - and leave the signale+-.
is this something that can be done?