Hi All,

I am looking for the best & most secure ONLINE or MOBILE wallet that I can use to transfer my ZEC mining rewards to , (Desktop and Hardware wallets are not an option currently) I was mininig ZEC to my Crypto Exchange Wallet direclty (BitOasis) but now , I need to find an alternative since the exchange has decided to delist ZEC

unfortunatley , I have read bad reviews about : Coinomi , Guarda , JAAX , in terms of security and I am confused about what to chose

Thanks !
The Problem is that the duct that I will connect the output of the Y connector to , is 5" , the Solid duct is a bit larger , (not sure how much)  , but the connection towards that solid duct is only 5" , so I am afraid that even if I use a bigger duct (10") , there will be a "Bottleneck" at the solid duct entrance side , and creating a new vent is unfortunatley not an option in my flat

You are right , I did think about that , and I am not sure if I should do any extra work , or is the current setup OK.
Currently , with the false cieling tiles open and without any ducting or anything , I have the below Temps:
Max PCB Temp: around 50 C.
Max Chip Temp: around 78  C.
Fan Speed on both Miners : 3480 rpm

What do you think ?
Do you mind telling me a bit more about your setup and how is it holding up ?

I am planning to use the ducts as outlets to let the hot air exit the room , the flexible duct will connect the Y connector to the existing solid HVAC duct , for the intake , I will leave some of the false cieling tiles open , so that Air can flow in to the room , Air temp is around 25 C to 30 C this time of year.
Why do you think this will overheat the miners ? and what do you suggest instead ?

Hello Miners !

I had to move my two Z9 Mini miners lately to a smaller room with no AC or Air Flow , and I am trying to find the best solution to cool and silence the miners as much as possible , I am in a bit of dilemma since I read and watched some conflicting advises about how to do proper ducting for your miners , so I would appreciate if you guys would weigh in and share your information , experinces and advises for my case.

The two Z9 mini's currently reside in a small room (1.5m x 4m) approximatley without AC , I am planning on connecting two 5" ducts to the two miners via 5" Fan Shrouds , combine these two ducts with a Y fitting connector , connect the Y connector to the exisitng HVAC system as shown in the diagram below:



Will connecting the two Z9 mini miners to the same 5" duct (via the Y Connector) cause the miners to heat ?

Currently , I don't have any ducting , I just opened some of these false cieling tiles to allow the hot air to exit , and I can feel that this is working because the room temp. is cooler now , and the miners fans speed has dropped , howerver , I want to overclock the two miners and I want to know if ducting 1) will be much more effective 2) or just as good as opening these tiles ? 3) or if it will actually be worse than the current setup and cause the miners to overheat ?