Ok.  I found my problem and got it fixed.  You have to run the Screen commands and start the main, loop and other screens.  As soon as I did that, the blocks in my pool started updating, the blocks got cleared and coins got sent to balance then paid out.

I found the answer to the problem in discord the link can be found off the yiimp page.

https://discord.gg/zcCXjkQ

Search for pool blocks not updating.  You'll find the thread in there.  There's a bash file there that helps solve the issue.

Thank you for the input.

The reason I chose yiimp was because another pool in the netherlands is using it with this coin but I didn't want to mine from the US into the NL (delays, etc).  I'm not sure what the error is but the NL pool doesn't seem to have this problem.  It'd be nice to fix this if possible if anyone else knows what the fix is. 

I'm having the same problem.  Did you ever figure out what was wrong?

When I look at my coin, it shows that the blocks are incrementing and updating.  My miner is finding blocks and they are being confirmed but they never "clear".  In the pool though (Scrypt pool), the coin's blocks don't seem to be updating.  Any help to get this setup correctly would be much appreaciated.

This is a picture of my coin config page.



This is a picture of the pool page.

Silly question here, but is the firmware on page one of this thread the most current?  If it is, can you add a feature to batch 2 for static IP configuration?  I'd like to address my devices so that they don't get lost in the dhcp/routing tables with other non miner hosts.