Show Posts
Received my miner 8/5/19. Even though USPS beat the box up pretty bad and tape holding box closed was broken all was well inside. Set up and running in less than 30 min. Eco mode runs .5 HW errors. Balanced mode runs between 1.7 and 2.2 HW errors.
Would really like to experiment with custom mode ,but not knowing baseline voltage and frequency setting for balanced mode I am afraid of burning unit up.
Can we get standard values for balanced and turbo mode please?
Overall happy with miner except fact that included power supply will not run it in turbo mode.
Would really like to experiment with custom mode ,but not knowing baseline voltage and frequency setting for balanced mode I am afraid of burning unit up.
Can we get standard values for balanced and turbo mode please?
Overall happy with miner except fact that included power supply will not run it in turbo mode.
FYI the power supply CAN run it in turbo, but due to regulatory requirements for the connector we used, we were forced to put that sticker on there. We have tested in in turbo, you just have to be careful and make sure you feel the power cable housing after running it in turbo for an hour or so...in some cases if the pin contacts are not secure the cable can heat up a lot, it should never feel more than warm to the touch.
Yes Sir it CAN and does run in turbo and beyond without getting hot. I understand having to apply the CYA sticker. I ran my Apollo at every frequency in custom mode. Fine tuning voltage with great results.
I am completely satisfied with the Apollo and included psu. Very nice American made machine. Thank you.
