Hello,
today a newpac arrived and I want to adjust the core voltage.
But I only can find measure points for 2pac devices?
One image in this point is very small I found where I can measure core voltage on newpac but the big image is not opening. Is there a bigger one?
Greets

I bought it from Amazon as NEW and the package looked like, but the vcore was definitively up to 1,5V so it seems someone operated before???

Is it possible that its a damage or can I test anything else??? I´m to new to this topic that its hard for me to say why this stick wont work like the other?

Hello,

I try my first steps on this mining topic and bought a raspberry pi 3b+ with 2 GekkoScience 2Pac BM1384 Asics.

I got all to run, but one of the 2Pacs went offline after few seconds. The measured vcore then goes to 0V and CGminer write, that this Asic went offline found 0 chips.
I found also a topic that vcore is to high so I set it to 1,3V like the other one which is working perfectly.

But all I try, the second one comes not or goes offline in short time.

I tried also with this 2Pac alone, same result. I tried also this stick directly on raspberry usb same result. comes few seconds and goes offline.

Could it be that the Asic is damaged? Its a one from amazon and the stick came with 1,5V vcore setting???