and for me it was so. the solution for me: open windows powershell (administrator) you enter : " bcdedit -set TESTSIGNING off ".this deactivates the test mode. restart the computer and start claymore.the program shows a red sign that it is not in test mode and restarts again. it should be fine now
worked once. asa a reboot was made hashrate dropped from 375 to 320. Already tried everything. When claymore tries to install driver after disabling test mode windows pops up a warning about unsigned driver installation. After reboot windows start in test mode so its supposed that driver was successfully installed but then the same hashrate.
heres my config file
-asm 2
-gser 1
-tt 60
-ttli 65
-wd 0
-cclock 1150
-y 1
-mode 1
-dbg -1
-powlim 20
-strap 5@2040,1@1900,1@1750,5@2000,1@1750,1@2000,1@1930,5@2000,2@1850,1@1850,1@1750,1@1900,1@2000
-rxboost 1
-cvddc 875,875,875,875,875,900,875,900,850,875,850,800,875
-mvddc 875,875,875,875,875,900,875,900,850,875,850,800,875
when i found that voltages values i figured out that somehow core voltage and memory voltage were linked so if i decrease core without also decreasing memory voltage it wont work. do you face the same behavior?