How can I switch my Davies Coins from Desktop-Wallet to the ERC-20 coins? Deadline for switching is 31.10.2020? Is out there an Tutorial? I can#t send the coins from the Desktop-Wallet to the App because in the App there is already an ERC-20-Adress. There is no Tutorial. How the people can change their coins.

It would be absolutely cheeky if the coins simply expire. Normally an automatic swap would also have to take place in the desktop wallet. Or there would have to be an address in the app where you can also send the old coins and then the automatic swap takes place there. Otherwise all coins are lost.

Me too.
Can you gave us some informations.
Where? And in which file we have to do changes?
The miner is very unstable!
Is there a new firmware anywhere?
The Hashrate drops always from 11 GH/s to 6 GH/s or 0 GH/s.
The Miner never reached the 13 GH/s constant.

Problem is solved.
FANs were destroyed by parcel service.

Hello HagssFIN,

thanks for your reply.
Yes, ports are open.
The internet connection seems allright.
At the weekend, I did some changes on the config.
When I deactivate the fans the miner starts up and starts with the mining.
But there are several fan config commands.
I found the command "fan_option":"1".
When I set this to zero it seems the miner deactivate the fans from the software site and doesn't check them.

This config I have run for 30 sec before I have reload the old config, because the temperature of the chips went up really fast to 88°C, without fans.

Normally when the miner gets energy, he starts up very fast and the fans are immediatly on 6000 rpm.
But in the web interface the fans show 0 rpm.

Could it be that the fans are defect or the control borad could not manage them?

It would be very nice, if anybody could post his fusionsilicon X7 miner config, so that I can compre both settings, where is my failure.

I hope not the fans or the control board is damaged.

Hello i have a problem with my FusionSilicon X7, too.

At home with DHCP and only behind a DSL-Router he works fine.
The miner starts up fast and begin with the mining.

But in the Datacenter the miner don't begin with the mining prozess.
I hope anyone can help me here with my problem.

And can posts here his X7 cgminer.conf.
So I can check my parameters, to solve the problem.

Thank you.

Needs the miner special ports open?
In the datacenter I can reach the web interface of the miner.
I can see, that he is connecting to the mining pool for a short time and send his user name to the mining pool.
But he don't starts his work, then.

He shows me that the pools are all alive.
But the fan is zero / he shows me 0 rpm.
The Miner goes up and get some work for 2-3 minutes.
Then the intern program cgminer restart new.
I think the cgminer is in a restarting loop.

Over the web interface I can send a ping. Traceroute and DNS works fine, too.

I hope anyone can help me.
Can anyone show / send me his Fusionsilicon X7 Config, so that I get a look what configs maybe are wrong.

It's wondering me because at home the miner has worked fine with the dhcp setting.
In the datacenter he gets not really up and began with the work.