Does anyone use claymore 15.0?
I got problem with setting up obviously,
Bat script is running properly and it is showing increase in mhs but when I want to monitor through nanopool web site it is showing 0 mhs, anyone with same issue?
When I first started using Claymore years ago, I had the same issue as you. Basically it connected to the right pool but after 5, 15,30, 60 minutes of checking my pools stats it showed 0 MH/s and no shares submitted.
The issue was that you need to manually change the epool.txt file with your info. Because by default it mines to Claymore's account. It was confusing because it was my pool but apparently the default Claymore pool was also the same one as mine. Eventually after 60 minutes of mining for Claymore it worked on my ETH address.
Most likely this is your issue.
Well,all comments considered,the thing I should do is paste into epool.txt : C:\Users\admin\\Downloads\Claymore12\Claymore12\EthDcrMiner64.exe -epool eu1-ethermine.org:4444
-ewall : address
-epsw x - strap1
Before that I added -driver install and then reboot pc and then deleted from script and then it looks like above.
Now I run the script and mining start but at the begining there is message driver is not installed and with the red letters written message try start the miner with command -driver uninstall and there is 0 mhs at nanopool as I stated before
If someone have further instructions what could be issue I would be greatful
Show Posts
