tanks for reply and sorry about the topic.


I noticed that when I change the cable, there is still the same problem on the healthy board. I tried the control board of another miner and both miners work with all cards but it shows error 53 .error massage :conf_para2_chain(2)

what is error code 43 on t2thm?
volt-diff-fail-chain(2)-chip(137 138 140)

hi every one . this topic is for miner problem like model that said in topic .
i must say to my compatriot miners




first i have a qus about error code 161 in innosilicon miner t2thm 30 th , enyone knows what is that error?





second i have an t2t hm miner and a led on power is on and it reset itself after few second .hashbord led on control board firs turn on and then turn off and again turn on except one .
i want to show its logs but i cant beacuse it is blank .i try to use innomonitor app and it shows error code 24 that mean hashboard fult but when switch 1 pin cable on control board that fulty hashboard is working and another hashboard is down.

tnx for reply  
i use mineral oil and for five t2t 25 th use that , it work properly . i think the oil has no problem.
but i fear that temp harm the device and i affraid to turn on the miner.
plus there isnt any log in the webgui to find out what happened to miner.
its similar in shape to t3 but has 35 th and in webgui and on the top of control board has t2t lable.

hi everyone i design a cooling sys with oil for innosilicon t2t ;

first, why these t2t look like t3 and have power beside them ?
       they have 35 th not 50.

second when they work for 30 min the temp was going high and suddenly the board not hashing and the status of them became "dead". the led light on board was blinking and i turned of the miner .Has this caused a problem?
 
what can i dofor the miner ?

hi
tell about the LED lights on the hashboard.
go to your config page and look for error.