Looking for tips on fan control. I am trying to set fan speeds and not sure I can do what I want. I know -tt 60 will set temperature target at 60 deg and -tt -70 will set fan speed to 70%. How do I implement more than one set of target temps? I am trying to set these values and fan speeds - 50deg at 60% - 63deg at 70% - 76deg at 80%
I am thinking I need this in my config
-tt 50 -tt -60
-tt 63 -tt -70
-tt 76 -tt -80
Is this correct or am I missing something?
Thanks in advance for any input
I am thinking I need this in my config
-tt 50 -tt -60
-tt 63 -tt -70
-tt 76 -tt -80
Is this correct or am I missing something?
Thanks in advance for any input
This is incorrect. -tt 60 sets the target temp to 60 degrees. So it sets the fan speeds at a variable setpoint to keep the card at 60 degrees. With some cards it needs a fan speed of 40% when other cards are set at 75% fan speed. So you can only set 1 target temp for each card.
Thanks I will continue to run fan controls in OverdriveNTool then I suppose.