 Show Posts
|
|
Pages: [1]
|
iannick@bronick.com you are currently renting skynet1 please check your pool account as it shows dead status. kindly switch to east based pools for better hash and stability. thankyou
|
|
|
|
d@zcial.comyou are currently renting skynet1 . your pool seems to be dead please check account settings
|
|
|
|
|
kindly switch pool for skynet2
|
|
|
|
Hi, currently renting these rigs from Mia. i cannot believe the stability of these rigs! SWEET! UnicornGS08  UnicornGS17 UnicornGS20 |
|
|
|
|
thanks for explaining mia
ptr it seema that your pool is not advisable to my rigs due to my rig location.
|
|
|
|
Appreciate the response. I was going off the limited stats i have available to me on my end, hence why i posted. I rent a lot of rigs and haven't run into the dropped rig situation with another Leaser's rig before. I apologize for assuming the worse and i hope you get the stability issues figure. Thanks.
No problem, i understand your reactions. Doing my best to get this figured out. Well i was also frantic seeing the rigs get dropped and auto disabled without any of my control. been my first time encountering such issue too. I'm coordinating with Mia about this. Thank you P.S. i was out of town these past few days for holy week vacation. but i'm here now  |
|
|
|
Again Skynet picked up my order on both rigs and both went down within 24 minutes in on a 72hr lease. One was refunded right away ( less the fee) and the other appeared to reboot and continue on. The rig that went down right away picked up my order yet again a couple hours later and is cancelled yet again. Either these rigs are very unstable or the rig is cherry picking orders and cancelling when something better comes along. This is definitely bad for renters as we are paying a fee to each time an order is picked up regardless whether seller follows through with the time allotment or not. Fee bombed because of seller is not in my interest. Wish there was a block available to exclude specific sellers when placing open orders. At this time i recommend avoiding either of the skynet 1 or skynet 2 rigs. Nothing you can do when the rigs pick up your open order though.  Could you submit that as a ticket to the helpdesk so we can take a look at implementing it? EDIT: if the rig goes down after 20-30 minutes you should effectively receive that time for free yes? rigs became very unstable after the leaserig.net maintenance.. still looking to all of the possibilities of why my rigs under performs. i have no capability of cancelling orders. i just receive notifications that rig went down after hiring. we dont get paid if we dont hash for atleast an hour. RIGS runs normal on my end.... please see screenshot below Skynet_1  Skynet_2  |
|
|
|
|
Hi everyone,
i had serious problems this last two days.
When the maintenance of Leaserig.net happened Skynet_1 and Skynet_2 are now hashing below 1mhash and automatically disconnects to LRP then leases were dropping and rigs were auto disabling.
i always get speed buffer filled error. Miaviator please help, my rigs were working just fine before the leaserig maintenance though.
will try to upgrade my ISP plan as soon as possible hope that would help.
|
|
|
|
hi there SKYNET_2 seems to be dead?
Hi Sieshin, Yes it is dead due to wrong pool configurations. Kindly check your user name and password settings for pools config. As error pertains to failed pool authentication. Make sure you are registered in that pool. Input in leaserig pool settings your "USERNAME.workername" and password. If this is a P2Pool kindly switch to non P2Pool. will extend lease hours once this has been resolved. Sorry for the late support, been drunk and wasted these past few days hehe. Skynet_2 is now hashing |
|
|
|
ive rented this user's rig for only 2 hours and it went perfect, without any trouble. The communication with this user was fast too and useful. Recommended!
Thank you for the Feedback Always here to serve @timoyskie  |
|
|
|
hi there SKYNET_2 seems to be dead?
Hi Sieshin, Yes it is dead due to wrong pool configurations. Kindly check your user name and password settings for pools config. As error pertains to failed pool authentication. Make sure you are registered in that pool. Input in leaserig pool settings your "USERNAME.workername" and password. If this is a P2Pool kindly switch to non P2Pool. will extend lease hours once this has been resolved. Sorry for the late support, been drunk and wasted these past few days hehe. |
|
|
|
hi there SKYNET_2 seems to be dead?
hi, please check and refresh page of your pool status in leaserig.net if alive and accepting shares, check your pool settings. check your dashboard for hashrates. i have checked the rig is working fine and accepting shares kindly check on your end |
|
|
|
Ive noticed it was still hashing but shows currently off in leaserig. Please just do check maybe you have a hardware problem.
hardware/rig is running fine. iam unable to connect to leaserig.net sorry for the inconveniece will compensate this issue as soon as possible |
|
|
|
I have a question about the reported hash speeds on LeaseRig.
I have two rigs that are mostly hired out all the time. The reported speeds they are running at when being hired are NOWHERE NEAR the speed of the rig itself. For example, I'm running at a constant speed of 7.2Mh/s, and on the site its telling me 0.89Mh/s. Sometimes it's higher, perhaps fluctuating between 1 and 5 Mh/s. When it's not being hired, I'm mining at clevermining.com or perhaps multicoin.us and the reported speed is about right at 7.2mh/s. So what's going on?
I'm thinking that perhaps the pools my hirers are choosing aren't so good, and therefore the share rate is down because of it. However this destroys my reputation - because people can see a graph of my rig's reported speed, and if they see it hovering between 1-5Mh/s when I'm saying it's 7.2Mh/s, they are going to go elsewhere. It's not my fault my hirers are choosing bad pools.
I also suspect the reported speed on Leaserig.net is completely different to that shown at a pool for some reason. If my rigs really were mining at only 1Mh/s then people would have complained - but none have yet, so I can only assume all is well. I just wish the hash rate on the site could be a true figure of my rig's performance.
Anyone else noticed anything or has any comments?
i am also experiencing this throughout the day. on the providers page sometimes my other rig shows off in the status and when checking the physical machine it self it runs consistently. the fluctuation of speed hashes was quite low or quite higher than what i can see from my rigs that supposed to be running and is really running at 1.3mhash indicated on my miner. however leaserig.net displays as low as 0.1 up to 1.8 which is really not as it is. its my first lease and good thing is nobody is complaining too. please fix this as it can put on a bad reputation on me as a starter. btw i am using 750 ti's on cudaminer. a little help for api calling is what i really need? |
|
|
|
Hi All, Rigs are now up and running! Ready for leasing at a very competitive price Please post your feedback on this thread whether good/bad!  For emergency issues that requires immediate attention please reach me through skype: timoyskie - online 24/7 Happy leasing! |
|
|
|
Thanks for the refund!  Thumbs up! |
|
|
|
Hi, Welcome to my trust thread for LeaseRig.net lessors can comment here. My RIG name are Skynet_1, Skynet_2 currently running at 1.3 Mh/s each, monitored and maintaned by me 24/7. Rent my rig with a great starting low price! will send 0.05 BTC for the deposit in a couple of days Hope to have a great business with you guys! |
|
|
|
Hi, Just rented your rig for 12 hours but im only receiving 4.1k khash for almost an hour know instead of 5.3khash that ive paid for, kindly check your rig. The panel shows you only rented for 6 hours which also happens to be the longest option we have for that rig... As to the Hash power... Looks like even though 2 of my gridseeds are reporting a hash rate, they're also not showing accepted shares. I've pointed another GPU at this rig to bring the khs up, extended your lease for 1 hour, and I'll credit you 1/5 of your payment to cover the 1/5 khs loss for the first 5 hours of your 6 hour lease. Thanks for bring this to my attention!!! my apologies i maybe confused of the time preference. kindly detail me on how ill receive the 1/5 credit? btw thank you for extending. TIA . thumbs up for the support will surely rehire next time |
|
|
|
Hi, Just rented your rig for 12 hours but im only receiving 4.1k khash for almost an hour know instead of 5.3khash that ive paid for, kindly check your rig. |
|
|
|
|
