Hello!

   I am super new, have been using T-Rex for ETH since mid-December. Since upgrading to 19.9 and reading more about the supported parameters I was excited to learn I could use --mt 0-6 and fine tune my cards memory similar to ETH pill w/o having to run two separate programs. At any rate I made the required changes and tested each level and landed on 4 giving me see results as 5 and 6 but higher rates than 3 so I settled in there. All cards are the same so it works damn good.

   Since using the parameter however  I got a message within T-Rex window "... unable to set... Run as admin.... " The only file I can force to run as Admin is the actual T-Rex file which I don't really mess with normally, I simply edited the batch file and run that. So at any rate I right clicked on the t-rex.exe and selected run as admin and then also tried with advanced> run as admin for everyone. With either of those selected it is able to load the --mt levels but also opens two command windows. I know this is only an annoyance but it's also possible I'm doing things entirely wrong. I figured someone here has seen this before and knows what to do.  I have 1 8x gpu rig and 1 test bench for new card testing and tinkering and both have the exact same issue.

TIA