Took the faulty machine to the spot with the working machines. Unplugged one of the working one. Use that eth cable and also the power supply. Still not working. Attached the eth cable and psu to the working one and booted up that and it works fine. So I think that we can assume that there is something that is not working as it should in the faulty machine.
Hi It worked on original firmware and also on Bliss firmware ( I also have the same Bliss firmware on three other L3 working fine). But when I moved the machine it stopped working.
I need some expert help on this. My Antminer just shows 0 on all 4 asic boards. Is it the status board that is faulty or is there some other issues? From Kernel log:
May 7 17:50:46 (none) local0.notice cgminer[381]: Start A New Asic Response.Chain Id:[1] May 7 17:50:46 (none) local0.notice cgminer[381]: tty_init 2 May 7 17:50:46 (none) local0.notice cgminer[381]: Start A New Asic Response.Chain Id:[2] May 7 17:50:46 (none) local0.notice cgminer[381]: tty_init 3 May 7 17:50:46 (none) local0.notice cgminer[381]: Start A New Asic Response.Chain Id:[3] May 7 17:50:46 (none) local0.notice cgminer[381]: open device over May 7 17:50:46 (none) local0.notice cgminer[381]: send cmd to get chip address May 7 17:50:48 (none) local0.notice cgminer[381]: Chain 0 ASIC 0 !!! May 7 17:50:48 (none) local0.notice cgminer[381]: Chain 1 ASIC 0 !!! May 7 17:50:48 (none) local0.notice cgminer[381]: Chain 2 ASIC 0 !!! May 7 17:50:48 (none) local0.notice cgminer[381]: Chain 3 ASIC 0 !!! May 7 17:50:48 (none) local0.notice cgminer[381]: Need to recheck asic num !!! May 7 17:50:49 (none) local0.err cgminer: Miner compile time: Sun Jan 14 00:00:57 CST 2018 type: Antminer L3+ Blissz v1.02 May 7 17:50:49 (none) local0.warn cgminer: Started cgminer 4.10.0