Hi,

I have the antminer s19 pro, and I actaully had problems with my miner, I installed the latest firmware from bitmain's site, only to find out that the latest version they have there, is older than the one I actually had when the miner arrived.
So I wanted to know if I could install the firmware of s19 since it's newer...

I actually did install the firmware of s19 and it didn't work well.
It didn't brick or anything, it's just didn't mine, and it thoght that the temperature was 255 degrees....

So anyway I installed the correct firmware for s19 pro.

Thanks

Hello,

I have the antminer s19 pro miner.
I updated to the latest firmware from bitmain's site, but now I actually have an earlier version than the one that was installed when i got the miner.
I can't find anywhere the version that I initially had.

Do you think it's possible to use firmware from antminer s19 in my s19 pro?
I saw that the s19 has firmware that is mucher newer than the one I currently have.

Thanks
Shai

I have an update:

I opened a ticket in bitmain site, and they recommended to flash the SD card.
so I flashed the SD card to recover the control board. Since then, not only that the second hashboard is still offline, now the other 2 hashboards that used to work, are in abnormal state and don't work at all...

would someone know what to do regarding this issue?





In addition to that, I opened the lid, and it looked like all the cables and wires were tight. I did try to switch the wires, and now boards 2 and 3 are online, and board 1 is offline.
so I guess that's good news.... right? I hope the the problem is with the wires (or PSU) but not the hashboards.
But anyway, the 2 boards that are online are in abnormal state, so the miner isn't hashing ....

Does anybody know how to get these type of wires?


I'd appreciate it if someone could tell me additional things I could try.

Thanks
Shai

I tried in 2 different ways, the one you suggested, and there is also a possibility to do a factory reset via the web page of the miner.
Anyway it didn't change the results. the second hashboard is still offline.


I updated the firmware, but it looks like I already had a later version.
The firmware version that came installed in the miner was from April 10th 2021, and now after I installed the firmware from bitminer's site, the version is Dec 11th 2020..
Anyway the second hashboard is still offline...

Hello everyone,

I purchased the Antminer s19 pro last week and it arrived 2 days ago.
when I start it up, it looks like 1 of the hash boards doesn't work well.
These are the lines from the log of the miner that are related to this issue:

2021-07-09 06:56:47 Chain[0]: find 114 asic, times 0
2021-07-09 06:56:54 Chain[1]: find 109 asic, times 0
2021-07-09 06:57:03 Chain[1]: find 109 asic, times 1
2021-07-09 06:57:11 Chain[1]: find 109 asic, times 2
2021-07-09 06:57:12 Chain 1 only find 109 asic, will power off hash board 1
2021-07-09 06:57:20 Chain[2]: find 114 asic, times 0

In addition, I see that only 2 hash boards out of the 3, are mining.

The mining value is 72 TH/s where it should be 110 TH/s

Please also see screenshots from the Miner's Dashboard:





Can someone please advise how to fix this issue?

Thanks
Shai