Ok, thank you waggy459, an update: today it shows my 0.005 Ether on wallet.matic. network, it just took almost 2 days to update!

Regard previous post on coinbase, that would be nice if coinbase and other large exchanges accept the polygon network. I think it's only a matter of time before they start to support it.

Hello, I need HELP on this, I'm utterly confused:

I imported my guarda wallet into metamask and kept the same address and used it in ethermine.org.  I added the polygon network to that address which is connected to polygonscan.com. I got 0.005 of Eth that shows inside metamask and the transaction is shown on polygonscan.com.  It doesn't show the 0.005 ETH on wallet.matic.network, I'm guessing it's because it's not a PoS-Weth but some other type of WETH? The 0.004 matic does show normally on wallet.matic.network.  

I went to my wallet on guarda.com and tried to add custom token by adding the contract 0x7ceb23fd6bc0add59e62ac25578270cff1b9619 but it rejected it and said "Incorrect Smart Contract Address." I contacted guarda as of why it wouldn't take the smart contract address and the guy said that they don't support the MATIC network but only support ETH/ERC-20 network.

Questions:
1. Is it ok that it doesn't show on PoS-Weth? Did I screw up something? Is it wrong to use the Guarda address on metamask?

2. What should I do now to transfer my WETH to Guarda (best and cheapest route)? Do I need to convert to usdc or to matic coin and then to Ether mainnet and would it then show on Guarda exchange?

Thank you in advance.