Show Posts
|
Pages: [1]
|
Why didn't you try something more:
1029 Ghs @
T front/back: 20 /44 Start volt /max volt: 0.32/0.625 Max watt: 150
|
|
|
Hello would it be possible in your opinion to drive 2x SP20 with a 1200 gold PSU (100A)
In detail at 1000 GH and 500w each => circa 125watt per connector (1000watt/8)
1000watt over the 12volt rail equals to 1000watt/12v = 84 A < 100 A
what about it?
too much 125 watt for each 6 pin pci connector?
|
|
|
i cannoct connect the miner also with direct cable miner-pc
the pc address is 192.168.0.xxx
i changed it according to dogie's guide to 192.168.1.1 and connect the miner
i changed the protocol into dhcp client ands save and apply
after no more connection, also repeating the same steps
the problem is that i didn't set the pools data
|
|
|
hello someone can help me? I changed the protocol in DHCP before inserting my pools information
Now I cannot access the S3
What can i do?
|
|
|
In case of modular PSU do i need to connect the papercllip togheter in any case? How can i do in a batter way?
|
|
|
Hello, someone can answer to my question: Is it possibile to use one power supply for 2/3 antminer s3 ?
Is it needed to make something with the ground 12volt ?
Have i to connect the cases of the miners togheter ?
Thank you
|
|
|
Which is the easiest methoid to scan the ip addresses already used ?
Not yet received my 3x units... waiting next week
|
|
|
Hello, my net has following specification
IP address 10.217.73.xxx
Subnet mask 255.255.248.0
Gateway 10.217.72.1
Someone can tell me what to do to configure the S3?
Ifwell understood i should connect directly the unit to the PC and set these values:
IP address 10.217.73.xxy
Subnet mask 255.255.248.0 (the same) Gateway also the same of the PC DNS primary 8.8.8.8 ? DNS secondary ?
Am I right? TK
|
|
|
|