Thank for feedback, Today i hook it up to a mw psu and do some tests.
I modded the fan system, machined the heatsisnk and replace the thermal grease, designed new panels for mounting noctua fans now im getting asic temp to 38c and vr 33c. Maybe my asics are tired.

Edit: confirm there are 5/6w of difference between axeos and smart plug (tried 3 different kinds) maybe a small sw bug.  The discrepancy get larger ( over 10w) with custom overclock.  

23w > 29w (meanwell psu) using default values.

Hi and thanks, I modded the box a little with a better fan and new thermal grease: ASIC temp 39°C / VR 33°C. Your firmware has been running smoothly for many hours without a single issue, 550 MHz / 12.5 V ~ 1.05 TH on average.

I only see a significant discrepancy between my smart plug and Axeos power monitor. The smart plug (which I know is accurate) reports that the miner is drawing 27 W at the wall, while the dashboard only shows 22.5 W. I guess this difference is due to PSU efficiency, with the extra power likely dissipated as heat.

Would it be useful to have an estimated real power draw on the dashboard?
Something like:
Power 22.5 W (-10/15% (editable) PSU efficiency: 4.5 W = 27 W)
assuming one is using the stock power supply?

Thanks for your work!

Thank you so much, i mean they are in order like this:

io0 - rx
gnd - tx
3v3 - en (last square pin)
(in the order of flipped image)

as for boot mode, i keep rx-tx attached then swap from io0 to gnd after clicking the switch?

Correct?
 

edit: just flashed via uart. all good, thank you!

Greetings, i have been reading this for a while, i want to flash my lv07, i dont have the clamp so im gonna solder pins use wires to hook up my uart adapter.
Would anyone lay down a schema of the pins? there are 6 and not sure which one to use.
Thanks for the great work that has been done, and tia!