just want to check: if the usb is modded to draw more than 500mA will a hub allow that (assuming you have it connected to sufficient power supply)?
I have tested it on a power supply which could go up to 5A, still the same thing. the BE100 chip gets hot and led doesnt blink and pc wont detect it.
Any help please ??
It does get hot.
Hotter than normal? Could be a short circuit then. Measure the resistance between VCC and GND.
I have tested a good working one and between the VCC and GND there is 7.3ohms and on the non working one it 0.5ohms
Where could the short circuit be ?