Just to clear things up, THANK YOU SO MUCH FOR THE HELP.

I figured it out. I didn't realize that after you extract the files to the STM software folder, there was an additional .exe you must install. Everything is good now.. Hitting 30 m/h. Debating on buying another..

Again,
Thanks guys..

Thanks not.you. However, my drivers are in the same location, but when I try and reinstall those drivers it says that the latest driver is already up to date. I actually tried each option in zadig as well as your method and its not populating under "Ports (COM & LPT)"

Ok, I installed the usb extension and have downloaded zadig. When I go to device manager when i turn on the GBlack, all the STM32 Virtual COM Ports populate. Well, they are listed under Universal Serial Bus Devices. Whenever I log on to BFGminer, i can connect to my server, but still no devices are found. Ive looked for which COM port they are on, but another website says it should be listed there.

Thanks for all the responses and help! So the consensus says do not use Raspberry pi with the GBlack asic miner. If that is the case, how do uninstall the raspberry pi and hook it to my PC? Do I hoop it up with usb through the pi? Or have to have a cable running from each board?

Thanks

Hello,

I have been mining now for some years, but I have only been mining with GPUs. I just bought a GBlack w/ the 5x80xGC3355 and I cannot figure how to setup raspberry pi. I am logged in and able to surf the internet n stuff through the Rasppi, but I just can't seem to figure out how to get this thing to start mining. I also have a few USB sticks and a gridseed I would like to use on my regular desktop if anyone can point me in the right direction. Yall's help will be GREATLY appreciated.

Thanks,
PJ