Show Posts
|
Pages: [1]
|
Hi! We just listed on our site and assigned rating "A3" to your ICO Advanced Miners (ACM). "A3" – rating denotes expectations of low investment risk. The project capacity is considered strong. This capacity may, nevertheless, be more vulnerable to adverse business or economic conditions than is the case for higher ratings. Additional information is available on our site https://icoinspect.com/ico/advanced-miners-acmBest regards, ICOinspect team what can you say now that all the information about this ICO just disappeared and the data on Twitter, Facebook is old and there is no data on their website that just doesn't work. where's the low-risk project? This was a scam right of the door... Right ? Any legal activity agains them ?
|
|
|
Spoondolies, KNC o Bitmain (400gh - 5.5th). También busco minero scrypt (28gh - 300gh). Miro unicamente el ratio gh/s al que lo venden, obviamente que valoro la eficiencia pero es algo secundario.
Un saludo, Nikolas
|
|
|
Pues eso... Dependiendo del precio puedo realizar pagos en bitcoin.
Un Saludo
|
|
|
¿Por cuanto vendes el S3 sin fuente y sin gastos de envío?
gracias
|
|
|
I am from spain and i have been looking into ebay and amazon but they all seem overpriced. Considering the price and electricity cost, do you know any website that sells price competitive secondhand bitcoin miners?
|
|
|
I have been mining for almost 1 week and a half 24/7 and my share was 0.02342%. this morning my righ went off for about 9 hours and I kept receiving bit coins with 0 contribution. My share was at the time 0,01300%. Now I have been mining for more than 8 hours and my share is only 0.00500%.
Is this going to continue? Why am I being punished so harshly ?
Thanks
|
|
|
I have a 4mb DSL. I am getting in 2 week 50mb fibre. Then that should solve the problem - I hope.
It's had nothing to do with your connection. You can archive smaller number by downclock the setting. I have done that... My 3 SP20 are running at 3ths in total. When I rise the W then they keep switching on and off... If I over clock 2 of them to reach 3th or so is fine, but when there are 3 ... Thanks
|
|
|
I have a 4mb DSL. I am getting in 2 week 50mb fibre. Then that should solve the problem - I hope.
|
|
|
I have about 110k of stale shares after mining for 3 days non-stop. Is this normal?
For 3th I am getting 0,005 btw per block found. Am I getting a fair pay out or am I doing something wrong... Maybe my internet connection stinks...
Regards,
Nikolas
|
|
|
Do you think that a corsair hx 1000 will be enough to run a SP20 with settings of 200 w in each of the four modules? Thanks!
Alternatively, can I use an hx1000 for 3 slots and an 560 for the fourth slot. All psu are corsair. Thanks again
|
|
|
uranus stinks too 
|
|
|
I bought a SP20 Jackson. I use 2x700w PSU but they keep switching off after 5min mining. Why?
Many thanks
Can you ask the support of this SP20? It's his PSU, Spondoolies will say the same thing. Yes, you are right. I bought today 2 second hand Uranus 850 (bronze) for 70euros from an outcast shop! The guy had in store at least 25 Radeon graphic cards and 20 PSU for sale. I thought he used the graphic cards to mine in the good old times. However, he was using them for phone unlocking  He have an Uranus 1050 for 60 euros on sale. Should I buy it? Thank in advance for everyones help!
|
|
|
What about silver-stone and uranus? What if I put two units of 850 or 1050 in each miner?
|
|
|
I am guessing you bought some crappy PSU's which were overly cheap and they lied on their loads.
You are right. They are relatively cheap... MARS MP700, i though they were going be more than enough but... I have 3x SP20 Jackson and I found that if I increase w more than 100 the PSU goes off... I should have been able to set the PSU to 280 to exploit the full potential. However, if I was lucky enough to have a good PSU, cables would not have lasted more than 1 week...
|
|
|
I bought a SP20 Jackson. I use 2x700w PSU but they keep switching off after 5min mining. Why?
Many thanks
|
|
|
|