hi
sorry if this has been asked before, but......
i've got 2 x s3 here
started to configure one of them.
got the pool details in ok.
when i change the wan network over to dchp, click change protocol and then apply and save, it just sits there saying "waiting for changes to be applied"
been about 2 hours now.
it's hashing and submitting results to the pool (about 420 - 430 gh/s) but i can't set up the other one until its finished.
any idea how long it could take ??
many thanks

many thanks
turned the screw just a fraction and seems to be working fine at the moment
not seen any hardware errors as yet, but if i do, how do i adjust the clock rate ??

thanks for the reply
using usb2
where is the voltage screw please, and which way to turn it (anticlockwise, i'd guess??)

hi all
got a little problem with my gekko science usb stock miner.
hashes fine at about 8-10 gh/s for between 5 - 15 mins, then just sits there doing nothing (steady green light).
the only way i can get it to hash again is to unplug and replug.
tried on win 7 & win 10.
direct into pc and on dlink powered hub.
using bfg miner.
any help would be greatly appreciated
many thanks.