I found that cutting the pins short on the connector side, leaving enough that I could grab with forceps after hearing the I could grab with the forces and pull out pretty easily. The pins heat much easier when cut short. I used an iron with about 780 degree f.   

Hi all,
Has anyone found a source for the LCD display panel on the display module?  I have not been able to find a part number on this.

Thanks for any assistance.

So I did find the part.  Digikey
NHD-C0216CIZ-FSW-FBW-3V3-ND

Lightfoot, have you traced out pin 6 of the 10 pin connector on a Titan cube?  I am reading 39 ohms on cube here.  I thought this was a good working cube as i was solid on all four dies before I blew the controller board with another cube.  I am afraid to fire it up as I only have one working controller until I get others fixed.  Have additional tools to arrive over weekend and then can work on the controllers.  Gonna try replacing the FPGA chip again.  Will follow your advice on replacing that.  Got a preheat table.  What you think?