I'm wanting to get into mining not so much for the mining reward but because I support the idea of decentralised currency and the power of peer to peer transactions.
However I have a problem with getting some Gridseed Blades up and running. Something on them is exploding. Please see the below photos.
This is my power supply unit.
![](https://ip.bitcointalk.org/?u=http%3A%2F%2Fi.stack.imgur.com%2F83CSN.jpg&t=664&c=6byGx_sBbIitsw)
I live in the UK so the voltage is set to 220V mode.
![](https://ip.bitcointalk.org/?u=http%3A%2F%2Fi.stack.imgur.com%2FBPsTD.jpg&t=664&c=hnN4kvJlRhVHdA)
This is the front of the PSU wired up. My multimeter reads 12v coming from the output.
![](https://ip.bitcointalk.org/?u=http%3A%2F%2Fi.stack.imgur.com%2F4grd1.jpg&t=664&c=geJRDuQ88dMWWA)
I'm in the middle of building a stack of blades but I need to overcome the problem of something in them exploding.
![](https://ip.bitcointalk.org/?u=http%3A%2F%2Fi.stack.imgur.com%2FYMiQ2.jpg&t=664&c=KNfcVF4WdBeuUA)
In this photo you can see there are three components that have exploded. What are these components? What would cause them to explode?
![](https://ip.bitcointalk.org/?u=http%3A%2F%2Fi.stack.imgur.com%2FcEDKl.jpg&t=664&c=pXetWJF3QqmXFQ)
This photo is for comparison, this is a good blade where the components haven't exploded.
![](https://ip.bitcointalk.org/?u=http%3A%2F%2Fi.stack.imgur.com%2FIfc7e.jpg&t=664&c=V-_S7UHsBz2_Wg)
I've tried to look for a datasheet or a gridseed blade board schematic but I can't find one.
Every time I connect a blade to my power supply these same components explode. What could be causing this to happen and what could I do to stop this from happening?
Also I would like to repair the Gridseed Blades that have already exploded, is there a schematic for this board, or at least what are the components that have been damaged?