Hello,

I do need a help. I'm running few rigs under ethOS on RX480 8GB. So my issue is, that on every rig in diffrent time I got problem "WATCHDOG: GPU 0 hangs in OpenCL call, exit" (different cards on different rigs and getting this error in different time in different rigs - from 60 minuts after start till few hours/days). So the problem is, that after getting message "Restarting OK, exit..." theoretically Claymore should restart, but I'm just getting "ssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssss" message all the time, while rig is on.

Does anybody know what issue it could be? For sure the matter of this message is raiser and overlocking (in some cases I'm gettin this problem with not overlocked cards)

When I do putting some commands to reboot.bash, it doesn't work at all :/ What could be an issue?

My config file is :

-mode 0 -colors 1 -di 012345 -dbg 1  -wd 1 -r 1 -epool eth-eu.dwarfpool.com:8008 -ewal ***/*** -epsw x -dcoin dcr -dcri 17,17,17,17,17,17 -dpool dcr.coinmine.pl:2222 -dwal **.** -dpsw **ccgmining

Thanks in advance

Hey guys, need help, using claymore 9.2,

the mining is okay but there is no hashrate data show on supernova dashboard, anyone can help?

the code i use is -dpool stratum+tcp://dcr.suprnova.cc:2255 -dwal xxxx.test1 -dpsw test

Please see the screenshot below.

I need to learn russian 

Is your GT 520 a 2GB card?

 If so, you're hitting the "DAG file got too big to fit on the card with the other data that also has to be there" issue that is affecting pretty much ALL 2GB cards at this point.

 This is a known issue, THERE IS NO LONG-TERM WORKAROUND, there is no way to avoid it, it's inherent to the design of ETH.


 Options are:

 1) Switch to Ethereum CLassic (ETC) or one of the other "ETH clones" that have a smaller DAG file and don't have this issue yet.
 2) Switch to XMR or ZEC or other such coins that don't have this type of issue at all.
 3) Retire the card
 4) Upgrade the card to a card with 3GB or more memory on the card.