Hello All,
Relatively new to the mining scene and trying to learn with some USB sticks how to configure CG miner. Ran into an issue. I have CG miner version 4.10 that was running two BFL Jalpenos and a Block disruptor. I recently acquired a NewPac BM1387. All four devices are plugged into an Anker USB 3.0 external hub with a usb fan for active cooling.
CG Miner 4.10 didn't detect the Gekko miner but the link to their version did but didn't detect the other miners. So Currently I have two instances of CG miner open (Version 4.10 for older miners and 4.11.1 for the Gekko Science one.
If the CG miners are ran solo the devices run fine however, if I try to run with both instances open I get an the following error "USB init open device failed, err -3 you don't have privilege to access - BSC device " on the CG miner 4.11.1. Even while getting this error on the CG 4.11.1 miner the other miner (4.10.0) continues to run fine with no errors.
Any thoughts on that causes this behavior? I tried to limit the number of USB devices on the first miner to see if that fixed it unfortunately it didn't. Below is the config I am currently using for the CG 4.10 miner.
{
"pools" : [
{
"url" : "stratum+tcp://us-east.stratum.slushpool.com:3333",
"user" : "[Redacted]",
"pass" : ""
}
],
"failover-only" : true,
"no-submit-stale" : true,
"api-listen" : true,
"api-port" : "4028",
"api-allow" : "W:192.168.1.0/24,W:127.0.0.1",
"--usb" :"3"
}
Link to the CG Miner Outputs:
https://ibb.co/cbf1wBK