Show Posts
|
Pages: [1]
|
Make sure that the card is visible in device manager as active device, and look in to gpuz after setting the clocks (does it accsept the clocks as the other 4 cards), I have a same problem with one of my cards, one of them not accsept clocks at first atempt, so I had to click in afterburner 2 or 3 times to get desired gpu and mem clock, after that all 4 cards hashing the same..
|
|
|
Hi there, msi rx470, with 16.11.4 I have blue screens and frezze , with 16.10.1 and 16.9.2 100% fans issuses. I'm mining for a year with these two versions of drivers, but now I have problems with one rig. What driver version is recomended, can anyone help me? All cards working at 0.98v, msi ab controls fans, clocks and voltage, hynix 1100/1900 and samsung 1100/2000. Rig with problem is Intel g1840, h81m plus, 4gb ddr3, 4 x msi rx470 4gb hynix.
|
|
|
I had a same problem on one of my rigs, msi rx470 cards, for a few months working with 16.11.4 but it wont work now. I instaled driver 16.9.2 and now it's working
|
|
|
Hi, I have a similar problem, I bought new xfx rx480 4gb, hynix memory, straps 1500 copied to upper, gpu 1100 mem 1900 -cvddc 980 mv, miner works for an hour and crashed , gpu power draw always goes near to 90w and more. With a -cvddc 940mv Im getting 80+w but miner immediately crash and says ''display driver stops working''. I tried to lower the gpu clock and memory clock, more or less mv , always the same result - crash and blue screen. I use also msi afterburner. I have more cards, but they are 470's and working great few months already.
Is there any chanse to do it to be stable?
|
|
|
I have 6 x msi rx470 4gb, had problems 100% fan and fan stop working on drivers 16.9.2 win10pro. After installing 16.11.4 fan errors gone, but I have another bug, one rig frezes after hour or two mining. I'm mining eth and etc for now, until some fix or update comes.
|
|
|
Thanks for fast reply Wacko, my fault, my cards are on -48mV , under mining gpuz shows 0.9813V, in iddle shows 1.0V. I dont remember what was the stock core voltage, I tried to set core to "0" mV in msi afterburner - no fix, still frezing after few hours , also tried to underclock the memory, but no difference except the lower hasrate. First I will underclock the gpu for 50mhz to see how stable it works. Thanks again!
|
|
|
Need help! Hi guys, I had a similar problem with 100% fans, mining on win10pro with 6 x msi rx470 4gb, 4 of them on ga970 with sempron x2, 2 of them on h81m with g1820, both rigs have 4gb ram. I used 16.9.2 drivers on both mashines for eth and there were no problems ever. First time switch to xmr I got 100% fan speed on both rigs runing claymore 9.7. Instaled 16.11.4 driver and now fans are ok - no 100%, but sempron mashine frezes after 1 or 2 hours mining, while Intel mashine works perfectly. All 6 gpus are moded, gpu 1100, mem 1900, core volt -480mV, low intensity mode. What to do next?
|
|
|
|