hello my mn run but gets since 48hr no rewards siad enabled block is corect dont now the Problem vps cold

how i get gnc from masternote???that was not one point in that installation guide

Hello,
since now 3 days i have the masternode but it dont enabeld in explorer also my adress is not in the list.

i download the wallet and make that

1.Open and Run the Gainer-qt.exe wallet for the first time.  
2.Your firewall and antivirus might pop up to allow connection. Please allow the connections by making appropriate tick marks.
3.In the lower left hand corner of the User Interface, you will see “Synchronizing with network” and other sync messages each time you open your Gainer Wallet. If there is a problem synchronizing, it may say “No Block Source Available” instead. If this happens, just close and re-open the wallet until it synchronizes.
4.Go to Help -> Debug Console.
5.In the Console window enter getaccountaddress 0 and copy the result. This is your MASTERNODE DEPOSIT ADDRESS, where you will deposit the coins to create a masternode. Pay 5000 Gainer exactly into this address. No more, no less.
-·Wait for the 1 confirmation of the transaction.
6.In the Console Debug window enter masternode genkey and copy the result. This is your MASTERNODE PRIVKEY.
7.Open Configuration File in Notepad. This config file is located at C:/users/***Your windows username***/appdata(hidden)/roaming/Gainer  Then paste in the following.

rpcuser=ANYTHINGHERE
rpcpassword=ANYTHINGHERE
listen=1
allowip=127.0.0.1
port=5118
masternode=1
masternodeaddr=YourIP:5118
masternodeprivkey=PRIVATEKEYREPLACETHIS


8.Now save and close the config file.
9.Close the wallet by going to File -> Exit.
Open the Gainer Wallet again by running Gainer-qt.exe. This is how you will always start the wallet going forward.
10. Wait for 15 confirmations of the transaction of 5000 coins.
Go to Tools -> Debug Console. Enter masternode start. You will see the response “Masternode started successfully”. Congratulations, your masternode is now running.
Now click the Masternodes tab that is now visible. You should see your new masternode appear in the list with the status PRE_ENABLE.
This will change to ENABLED after a small amount of time. All masternodes need to be active for a certain amount of blocks before they are recognized by the network and eligible for rewards.


is that all
yes my ports 5118 are open

but all is running over wlan is that posoble thx

hello,
yesterday i start gainer masternode at 6pm ....wallet Show aktiv.... masternode till today not enabled in Explorer .....someone help

I have one written by a friend of me.
control the temp of each l3/l3+ and if more than 65temp/variable!! core than goes 5 step on voltage . with ip email alert also posible sms.
i used it because of the fire problem and demage risk for the core

hi i have the L3 miner now for 1 month and till yesterday running well but now is down because high temperatur.
did someone know something how to fix this...... software show after 24hour 85grad and because of that miner goes on and out did someone have the same problem
regards

also you can offer places to rent for some miner owner for 10centkwh and make $$$$$$$$$$$$$$$$$$$$$$ lol i pay in germany 16,5cent