Hallo zusammen,

woher bekomme ich DE sowas?

I'm looking for trusted/tested PSU recommendations.

What I need:

Input IEC C13/C20 200-240V, RJ-45 remote management, single port on/off switchable via app/browser


Output 200-240V, 4x - 8x IEC C14

What I found so far are two models from CyberPower: PDU20SWHVIEC8FNET, PDU15SWHVIEC8FNET
they are not cheap ...

What are you guys using?

no text

I'm on Win 7 x64 and build some ccminer 2.2.2 with different CUDA version, but sofar I didin't notice increase compared to CUDA 8, driver is 385.69. Tried lbry, lyra2v2, lyra2z.
Did someone really have increase in some algo, where?

hi guys,

what's the actually recommended version for doing this?
atm I'm using krnlx, because from that I saw at the github sources from some of the authors all are using the same code since 09/2016.
or is there somewhere a faster version?

Hi,
I'm new here, hope somebody could help with this rather strange behaviour:

fresh install of win7x64, new RX580 4GB, drivers tested 17.4.3, 17.4.4, 17.5.2, 17.6.2

I install the drivers, fire up the miner, eth.claymore 9.5
It sees the card, with 4 GB, starts to mine @ 24,4
Then I quit, go to other folder with same config, only v9.6, srat, miner sees only 3 GB, crashes, go back to v.9.5 same crash
go to other folder with zec.xxx, same crash
Uninstall driver with DDU, reinstall, same crash.
only reinstall helps.

I'm clueless what this causes.. any hint's what I'm doing wrong??